A kitchen worth keeping,
freighted into Innisfail.
The cabinetry that goes into a Innisfail kitchen is the same cabinetry we put in our own installed jobs: 18mm moisture-resistant board, laser-bonded edging, Blum hardware. What differs is that your trades fit it rather than ours.
The short answer
Every cabinet is cut to your wall lengths rather than picked from catalogue widths, then freighted to Innisfail north along the Bruce Highway. 18mm moisture-resistant board, laser-bonded edging and soft-close hardware as standard. Installation in Innisfail is by your builder or kitchen installer, working from the dimensioned service drawings that ship with the order.
What brief does Innisfail actually set?
As the service town for the district, the housing here runs from century-old cottages to new estate builds, and almost none of it suits a catalogue cabinet width. Every run we cut is drawn to the wall it is going on. Wet-season humidity here is the hardest test a kitchen carcass gets anywhere in Australia, and it is the reason we do not sell 16mm standard board at all.
What is the run to Innisfail?
Your kitchen is cut in Rockhampton and freighted north along the Bruce Highway. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Innisfail?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in Queensland that is QBCC. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
How do I plan around the plumbing I already have?
Keeping the sink and the waste where they are is the single cheapest decision available in a kitchen renovation, and moving them is the one most likely to find a problem inside a wall. If the layout works with the existing points, keep them. If it does not, get the plumber to look before the drawing is approved rather than after the cabinets land in Innisfail.
How do I measure from Innisfail with nobody visiting?
Because we do not visit Innisfail, your measurements are the drawing. Wall to wall at three heights and use the smallest number. Ceiling height in every corner, because floors are never level. Every window and door with its distance from the nearest corner. Where the waste, the water and the power are now. Then a photograph of each corner of the room. Our measuring guide lists the lot, and a designer checks your numbers against the photographs before anything is cut.
What actually ships with the order?
A numbered plan and elevations, a service drawing marking every waste, water point and outlet for your Innisfail plumber and electrician, the hardware bagged per cabinet, kickboards and end panels cut to length, and fillers where the room needs them. Nothing on that list is an extra. The service drawing in particular is what stops a cabinet being cut on site to clear a pipe nobody planned for.
Where else do you ship in Far North Queensland?
We ship to Port Douglas, Mareeba, Atherton, Tully, Mossman, Cooktown, Weipa, Gordonvale and the rest of the region on the same route. The Far North Queensland page covers the region, and Queensland covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Innisfail
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in Queensland.
The specification
Built for this
climate, not a catalogue.
Humidity is the design constraint here, not heat. Through the wet season a standard-core carcass takes on moisture at the cut edges and swells, and once a panel has swollen the door never sits square again. Everything we ship is 18mm moisture-resistant board with laser-bonded edging — no glue line for water to track along.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Innisfail kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Magic corner pull-out
The blind corner stops being the cupboard you empty twice a year. The front tray swings out and the back tray follows it.
See how it works →
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Innisfail — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Innisfail?
Yes. Innisfail is served north along the Bruce Highway, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Innisfail?
No. Our own installation team works Central Queensland only. In Innisfail your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Innisfail?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most Far North Queensland orders go flat.
Who can do the plumbing and electrical in Innisfail?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In Queensland, QBCC is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
How long will a Innisfail order take?
It depends on the kitchen and the freight route, so it is stated on your quote for your job rather than guessed here. What you can plan around is the sequence: drawing, your sign-off, cutting, then freight.
Can I add pull-downs and organisers to a Innisfail kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Innisfail order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Blum runners fitted before it leaves
Stone on a compact run
Full-height joinery, fitted in days
Innisfail, QLD
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Innisfail kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.