No showroom in Atherton.
No catalogue widths either.
The cabinetry that goes into a Atherton kitchen is the same cabinetry we put in our own installed jobs: 18mm moisture-resistant board, laser-bonded edging, Blum hardware. What differs is that your trades fit it rather than ours.
The short answer
Yes. Nothing about Atherton changes the product: 18mm moisture-resistant board, laser-bonded edging and soft-close hardware on every cabinet, cut to your drawing and freighted north along the Bruce Highway. What changes is the freight line on the quote and who fits it, because installation outside Central Queensland is your own builder or installer rather than us.
What brief does Atherton actually set?
Out here a missing bracket is not an inconvenience, it is a fortnight. Everything is packed against a numbered drawing and checked before it leaves, because the cost of getting it wrong is measured in distance rather than dollars. Wet-season humidity here is the hardest test a kitchen carcass gets anywhere in Australia, and it is the reason we do not sell 16mm standard board at all.
What is the run to Atherton?
Your kitchen is cut in Rockhampton and freighted north along the Bruce Highway. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Atherton?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in Queensland that is QBCC. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
What goes wrong with cheap cabinetry first?
In a predictable order: the edging lifts near the sink and the dishwasher, then water gets into the exposed core and the panel swells, then the drawer runners start to drag, then the doors stop lining up because the hinges have no adjustment left. None of that is bad luck. It is what 16mm standard-core board with glued edging and unbranded hardware does, and it is the reason we do not sell it.
Can I order the kitchen in stages?
Not every Atherton job needs the whole kitchen at once. Builders regularly take the base run first and the overheads and pantry later, and renovators sometimes take the kitchen now and the laundry in six months. The drawing stays on file, so a later order matches the first exactly - same board, same colour batch where we can, same hardware. Say so on the quote request and it is priced in stages.
What if the walls in Atherton are not square?
They will not be. Almost no wall in any house is, which is why every run is drawn with scribe allowance at the ends and why we ask for wall measurements at three heights rather than one. The scribe pieces are the strips that take up the difference between a square cabinet and a wall that leans. They ship with the order, and your installer cuts them to the wall on the day.
Where else do you ship in Far North Queensland?
We ship to Port Douglas, Mareeba, Innisfail, Tully, Mossman, Cooktown, Weipa, Gordonvale and the rest of the region on the same route. The Far North Queensland page covers the region, and Queensland covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Atherton
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in Queensland.
The specification
Built for this
climate, not a catalogue.
A kitchen here spends months in air that never really dries out. That is why we will not quote 16mm standard board at any price — it is the cheaper option that costs the most, because a swollen carcass cannot be adjusted back into square.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Atherton kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Magic corner pull-out
The blind corner stops being the cupboard you empty twice a year. The front tray swings out and the back tray follows it.
See how it works →
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Atherton — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Atherton?
Yes. Atherton is served north along the Bruce Highway, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Atherton?
No. Our own installation team works Central Queensland only. In Atherton your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Atherton?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most Far North Queensland orders go flat.
Who can do the plumbing and electrical in Atherton?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In Queensland, QBCC is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
Can I see a sample before ordering in Atherton?
Yes. Door, board and edging samples are posted out, and for most people that settles the colour question better than a screen does. Ask when you send the dimensions through.
Can I add pull-downs and organisers to a Atherton kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Atherton order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Laser-bonded edging, no glue line
Samples brought to you
Concrete-look doors, matte black hardware
Atherton, QLD
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Atherton kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.