A kitchen worth keeping,
freighted into Sorell.
We do not have a showroom in Sorell and we do not need one. Send the measurements, a designer draws it, and you see the drawing and the price before anything is cut.
The short answer
Every cabinet is cut to your wall lengths rather than picked from catalogue widths, then freighted to Sorell south then by sea across Bass Strait. 18mm moisture-resistant board, laser-bonded edging and soft-close hardware as standard. Installation in Sorell is by your builder or kitchen installer, working from the dimensioned service drawings that ship with the order.
What is a kitchen up against in Sorell?
Access is usually the deciding factor here — townhouses, units, narrow hallways, stairs. A flat carton goes where an assembled cabinet cannot, and it is often the only way to get a full kitchen into the room without taking a window out. Cold, damp winters in a lot of uninsulated older housing, which is where cheap board fails first.
How is a Sorell order freighted?
Your kitchen is cut in Rockhampton and freighted south then by sea across Bass Strait. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Sorell?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in Tasmania that is Consumer, Building and Occupational Services. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
How do I plan around the plumbing I already have?
Keeping the sink and the waste where they are is the single cheapest decision available in a kitchen renovation, and moving them is the one most likely to find a problem inside a wall. If the layout works with the existing points, keep them. If it does not, get the plumber to look before the drawing is approved rather than after the cabinets land in Sorell.
How do I measure from Sorell with nobody visiting?
Because we do not visit Sorell, your measurements are the drawing. Wall to wall at three heights and use the smallest number. Ceiling height in every corner, because floors are never level. Every window and door with its distance from the nearest corner. Where the waste, the water and the power are now. Then a photograph of each corner of the room. Our measuring guide lists the lot, and a designer checks your numbers against the photographs before anything is cut.
What actually ships with the order?
A numbered plan and elevations, a service drawing marking every waste, water point and outlet for your Sorell plumber and electrician, the hardware bagged per cabinet, kickboards and end panels cut to length, and fillers where the room needs them. Nothing on that list is an extra. The service drawing in particular is what stops a cabinet being cut on site to clear a pipe nobody planned for.
Where else do you ship in Hobart and the South?
We ship to Kingston, New Norfolk, Huonville, Brighton, Cygnet, Geeveston, Oatlands on the same route. The Hobart and the South page covers the region, and Tasmania covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Sorell
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in Tasmania.
The specification
Built for this
climate, not a catalogue.
Cold, damp winters in older uninsulated housing produce condensation, and condensation sits on the underside of a benchtop and in the back of a sink cabinet where nobody looks. Moisture-resistant board handles that; standard board swells quietly for a year and then lets go.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Sorell kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →
Drawer organisers
Cutlery, knives and spices in fitted trays cut to the drawer, instead of a plastic tray that slides around in it.
See how it works →
Deep drawer fit-out
Dividers and rails that keep a deep drawer from turning into a single pile you dig through.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Sorell — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Sorell?
Yes. Sorell is served south then by sea across Bass Strait, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Sorell?
No. Our own installation team works Central Queensland only. In Sorell your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Sorell?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most Hobart and the South orders go flat.
Who can do the plumbing and electrical in Sorell?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In Tasmania, Consumer, Building and Occupational Services is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
How long will a Sorell order take?
It depends on the kitchen and the freight route, so it is stated on your quote for your job rather than guessed here. What you can plan around is the sequence: drawing, your sign-off, cutting, then freight.
Can I add pull-downs and organisers to a Sorell kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Sorell order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Rangehood set into assembled overheads
Appliance garage, hardware fitted before delivery
Kitchen into dining, one palette
Sorell, TAS
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Sorell kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.