A kitchen drawn for Gosford,
not for a catalogue.
Cut to your wall lengths and your ceiling height, pre-drilled, labelled per cabinet and freighted to Gosford flat or assembled. You decide which after you see both on the same quote.
The short answer
Kitchens for Gosford are drawn in Rockhampton from the measurements you send, approved by you before anything is cut, then packed flat or assembled and freighted south along the Pacific Highway. The quote itemises every cabinet, the benchtop by material and metre, the hardware by brand and the freight separately. We supply only — your trades install it.
What is a kitchen up against in Gosford?
Access is usually the deciding factor here — townhouses, units, narrow hallways, stairs. A flat carton goes where an assembled cabinet cannot, and it is often the only way to get a full kitchen into the room without taking a window out. Salt air and a lot of 1970s brick houses being opened up, which usually means the run gets longer and the island arrives.
How is a Gosford order freighted?
Your kitchen is cut in Rockhampton and freighted south along the Pacific Highway. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Gosford?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in New South Wales that is NSW Fair Trading. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
How do I plan around the plumbing I already have?
Keeping the sink and the waste where they are is the single cheapest decision available in a kitchen renovation, and moving them is the one most likely to find a problem inside a wall. If the layout works with the existing points, keep them. If it does not, get the plumber to look before the drawing is approved rather than after the cabinets land in Gosford.
What should be ready before the kitchen lands?
The old kitchen out, the floor as level as it is going to get, walls patched and painted where the cabinets will not cover them, and the plumber and electrician booked for the days after the fit rather than the same day. Painting after the cabinetry is in is slower and the cut-in never looks as good. Our installation guide sets out the order of trades.
Would a kitchenette suit the room better?
If the room in Gosford is a studio, a granny flat, an under-house conversion or a short-stay unit, a kitchenette may be the right answer and it starts at $4,500. Sink, bench, cold storage, and a cooktop where the run allows. Same carcasses and the same Blum hardware as a full kitchen, in a fraction of the length - and it fits through a doorway that a full run would not.
Where else do you ship in the NSW Central Coast?
We ship to Wyong, Terrigal, The Entrance, Woy Woy, Avoca Beach, Umina Beach, Ettalong Beach, Toukley and the rest of the region on the same route. The the NSW Central Coast page covers the region, and New South Wales covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Gosford
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in New South Wales.
The specification
Built for this
climate, not a catalogue.
The seasonal swing here moves timber and board more than a steady climate does, and the joint that gives first is almost always the edge. Laser-bonded edging is fused to the panel rather than glued to it, so there is no seam to lift.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Gosford kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →
Drawer organisers
Cutlery, knives and spices in fitted trays cut to the drawer, instead of a plastic tray that slides around in it.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Gosford — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Gosford?
Yes. Gosford is served south along the Pacific Highway, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Gosford?
No. Our own installation team works Central Queensland only. In Gosford your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Gosford?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most the NSW Central Coast orders go flat.
Who can do the plumbing and electrical in Gosford?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In New South Wales, NSW Fair Trading is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
How long will a Gosford order take?
It depends on the kitchen and the freight route, so it is stated on your quote for your job rather than guessed here. What you can plan around is the sequence: drawing, your sign-off, cutting, then freight.
Can I add pull-downs and organisers to a Gosford kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Gosford order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Kitchenette, delivered assembled
Samples brought to you
Island with seating overhang
Gosford, NSW
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Gosford kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.