A kitchen for Yass,
drawn to your walls.
A kitchen cut to your measurements rather than picked from catalogue widths, packed flat for the run to Yass or delivered with the doors already hung and adjusted.
The short answer
A Yass kitchen is quoted from your measurements and photographs, not from a site visit, and the quote is fixed and itemised with freight shown as its own line. It is cut in Rockhampton and ships south along the Hume Highway. You choose flat packed or delivered assembled on the same drawing. Fitting is done by your own trades — our installation team works Central Queensland only.
What brief does Yass actually set?
Farm houses take a kind of use that suburban kitchens do not — boots, buckets, big cooking, and a back door that is really the front door. The specification we ship assumes that rather than hoping otherwise. Alpine and near-alpine housing, where kitchens are used hard in season and left cold and empty out of it.
What is the run to Yass?
Your kitchen is cut in Rockhampton and freighted south along the Hume Highway. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Yass?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in New South Wales that is NSW Fair Trading. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
Do I supply the appliances, or do you?
Most Yass orders come with the appliances already chosen, and that is the easier way round. Send us the model numbers, or the cut-out dimensions from the spec sheet, and the cabinets are cut to take them. If you would rather we supplied them, they are quoted as their own lines. What does not work is guessing: a 900mm cooktop in a cabinet cut for 600mm is a new cabinet, not an adjustment.
Can I change the drawing after I approve it?
Before it is cut, yes, and changes at that stage cost nothing but time. Once the panels are cut they are cut to your sizes and cannot be re-used on another job, which is why the approval step exists and why we would rather you took an extra week over it. Read the elevations as carefully as the plan: most late changes are about where a door swings or which side of the sink the dishwasher sits, and both are obvious on the elevation.
What goes wrong with cheap cabinetry first?
In a predictable order: the edging lifts near the sink and the dishwasher, then water gets into the exposed core and the panel swells, then the drawer runners start to drag, then the doors stop lining up because the hinges have no adjustment left. None of that is bad luck. It is what 16mm standard-core board with glued edging and unbranded hardware does, and it is the reason we do not sell it.
Where else do you ship in the Southern Tablelands and Snowy?
We ship to Goulburn, Queanbeyan, Cooma, Jindabyne, Bowral, Moss Vale, Mittagong, Bungendore and the rest of the region on the same route. The the Southern Tablelands and Snowy page covers the region, and New South Wales covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Yass
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in New South Wales.
The specification
Built for this
climate, not a catalogue.
Kitchens here are warm and steamy for a few hours and cold for the rest. That cycling is what lifts glued edging off a panel, and it is the single best argument for the specification we ship as standard.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Yass kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Magic corner pull-out
The blind corner stops being the cupboard you empty twice a year. The front tray swings out and the back tray follows it.
See how it works →
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Yass — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Yass?
Yes. Yass is served south along the Hume Highway, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Yass?
No. Our own installation team works Central Queensland only. In Yass your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Yass?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most the Southern Tablelands and Snowy orders go flat.
Who can do the plumbing and electrical in Yass?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In New South Wales, NSW Fair Trading is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
Is there a deposit to get a Yass quote?
No. The drawing and the itemised quote cost nothing and carry no obligation. Payment terms for the order itself are stated on that quote.
Can I add pull-downs and organisers to a Yass kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Yass order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Laser-bonded edging, no glue line
Service drawings for your trades
Concrete-look doors, matte black hardware
Yass, NSW
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Yass kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.