Naracoorte kitchens,
cut to your room.
Every Naracoorte order ships with a numbered plan, elevations and a service drawing marking every waste, water point and outlet, so your plumber and electrician are not guessing.
The short answer
A Naracoorte kitchen is quoted from your measurements and photographs, not from a site visit, and the quote is fixed and itemised with freight shown as its own line. It is cut in Rockhampton and ships west via the Western and Princes highways. You choose flat packed or delivered assembled on the same drawing. Fitting is done by your own trades — our installation team works Central Queensland only.
Why does the specification matter in Naracoorte?
Out here a missing bracket is not an inconvenience, it is a fortnight. Everything is packed against a numbered drawing and checked before it leaves, because the cost of getting it wrong is measured in distance rather than dollars. Cool, wet winters and a strong renovation market in the older timber housing stock.
How does it reach Naracoorte?
Your kitchen is cut in Rockhampton and freighted west via the Western and Princes highways. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Naracoorte?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in South Australia that is SA Consumer and Business Services. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
Can I change the drawing after I approve it?
Before it is cut, yes, and changes at that stage cost nothing but time. Once the panels are cut they are cut to your sizes and cannot be re-used on another job, which is why the approval step exists and why we would rather you took an extra week over it. Read the elevations as carefully as the plan: most late changes are about where a door swings or which side of the sink the dishwasher sits, and both are obvious on the elevation.
What goes wrong with cheap cabinetry first?
In a predictable order: the edging lifts near the sink and the dishwasher, then water gets into the exposed core and the panel swells, then the drawer runners start to drag, then the doors stop lining up because the hinges have no adjustment left. None of that is bad luck. It is what 16mm standard-core board with glued edging and unbranded hardware does, and it is the reason we do not sell it.
What happens if something arrives damaged?
Check the delivery against the numbered drawing on the day it lands in Naracoorte, before the truck leaves if you can. Count the cartons, look at the door and drawer fronts. If a panel is damaged or a carton is missing, photograph it and ring the studio the same day. A replacement is cut from the drawing we hold on file, so it matches the rest of the kitchen rather than being re-measured from scratch.
Where else do you ship in the Limestone Coast?
We ship to Mount Gambier, Millicent, Penola, Robe, Bordertown, Port MacDonnell on the same route. The the Limestone Coast page covers the region, and South Australia covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Naracoorte
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in South Australia.
The specification
Built for this
climate, not a catalogue.
Cold mornings and hot afternoons in the same day are hard on a cabinet. Materials expand and contract, glued edging works loose at the corners, and doors drift out of alignment. A fused edge and three-way adjustable Blum hinges are the answer to both halves of that.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Naracoorte kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Magic corner pull-out
The blind corner stops being the cupboard you empty twice a year. The front tray swings out and the back tray follows it.
See how it works →
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Naracoorte — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Naracoorte?
Yes. Naracoorte is served west via the Western and Princes highways, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Naracoorte?
No. Our own installation team works Central Queensland only. In Naracoorte your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Naracoorte?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most the Limestone Coast orders go flat.
Who can do the plumbing and electrical in Naracoorte?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In South Australia, SA Consumer and Business Services is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
Can I see a sample before ordering in Naracoorte?
Yes. Door, board and edging samples are posted out, and for most people that settles the colour question better than a screen does. Ask when you send the dimensions through.
Can I add pull-downs and organisers to a Naracoorte kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Naracoorte order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Laser-bonded edging, no glue line
Black joinery, marble bar
Oak run, doors hung and adjusted before delivery
Naracoorte, SA
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Naracoorte kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.