The kitchen, delivered.
Fitted out, not stripped back.
Drawn to your room in Rockhampton and freighted to Albury, flat packed or delivered assembled. Same board, same Blum hardware, same drawings as every kitchen we build.
The short answer
We supply Albury, we do not install there. The cabinetry is cut to your wall lengths and ceiling height rather than selected from catalogue widths, then freighted south along the Newell Highway as flat cartons or as assembled cabinets, whichever your quote compares better on. Specification is the same either way and the same in every state: 18mm moisture-resistant board, laser-bonded edging, Blum hinges and full-extension runners.
What does Albury housing do to a kitchen?
As the service town for the district, the housing here runs from century-old cottages to new estate builds, and almost none of it suits a catalogue cabinet width. Every run we cut is drawn to the wall it is going on. Irrigation-town wealth and a lot of farm housing, where a kitchen is expected to take twenty years of hard use.
How does the kitchen get to Albury?
Your kitchen is cut in Rockhampton and freighted south along the Newell Highway. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Albury?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in New South Wales that is NSW Fair Trading. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
What suits a granny flat or a rental in Albury?
A good share of what we ship to Albury goes into secondary dwellings, granny flats and rentals. Those kitchens fail in a predictable order - edging near the sink, then drawer runners, then hinge adjustment - and all three are specification, not bad luck. The board, edging and hardware we ship as standard are chosen so the rental kitchen and the owner kitchen are the same kitchen.
Can you match something I have already seen?
Usually, if what you like is the door, the colour and the proportion rather than a specific brand's product. Send photographs with the quote request and say what it is you are responding to in them, because that is more useful than a style name. Our styles guide works through the eighteen looks people ask for most and what each one actually needs.
Do I supply the appliances, or do you?
Most Albury orders come with the appliances already chosen, and that is the easier way round. Send us the model numbers, or the cut-out dimensions from the spec sheet, and the cabinets are cut to take them. If you would rather we supplied them, they are quoted as their own lines. What does not work is guessing: a 900mm cooktop in a cabinet cut for 600mm is a new cabinet, not an adjustment.
Where else do you ship in the Riverina?
We ship to Wagga Wagga, Griffith, Leeton, Narrandera, Tumut, Deniliquin, Temora, Junee and the rest of the region on the same route. The the Riverina page covers the region, and New South Wales covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Albury
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in New South Wales.
The specification
Built for this
climate, not a catalogue.
Four real seasons means four cycles of movement a year. Over a decade that is what separates a kitchen that still closes properly from one that does not, and it is decided by the edging and the hinge, not by the door colour.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Albury kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →
Pull-down wall basket
The top shelf of an overhead, brought down to where you can reach it. The shelf you stopped using becomes storage again.
See how it works →
Drawer organisers
Cutlery, knives and spices in fitted trays cut to the drawer, instead of a plastic tray that slides around in it.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Albury — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Albury?
Yes. Albury is served south along the Newell Highway, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Albury?
No. Our own installation team works Central Queensland only. In Albury your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Albury?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most the Riverina orders go flat.
Who can do the plumbing and electrical in Albury?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In New South Wales, NSW Fair Trading is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
How long will a Albury order take?
It depends on the kitchen and the freight route, so it is stated on your quote for your job rather than guessed here. What you can plan around is the sequence: drawing, your sign-off, cutting, then freight.
Can I add pull-downs and organisers to a Albury kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Albury order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Kitchenette, delivered assembled
Drawer fronts aligned on the bench, not on site
Tall units arrive as built boxes
Albury, NSW
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Albury kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.