Custom kitchens
freighted to Blacktown.
The cabinetry that goes into a Blacktown kitchen is the same cabinetry we put in our own installed jobs: 18mm moisture-resistant board, laser-bonded edging, Blum hardware. What differs is that your trades fit it rather than ours.
The short answer
Every cabinet is cut to your wall lengths rather than picked from catalogue widths, then freighted to Blacktown south along the Pacific and New England highways. 18mm moisture-resistant board, laser-bonded edging and soft-close hardware as standard. Installation in Blacktown is by your builder or kitchen installer, working from the dimensioned service drawings that ship with the order.
What brief does Blacktown actually set?
Resale sits behind most kitchens in these suburbs, and a buyer reads a kitchen in about four seconds. What carries that is alignment: even gaps, doors that sit flush, drawers that close themselves. All three are hardware and assembly, not budget. Most enquiries here are apartments and semis where a built cabinet will not fit through the door, which is exactly what flat pack solves.
What is the run to Blacktown?
Your kitchen is cut in Rockhampton and freighted south along the Pacific and New England highways. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Blacktown?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in New South Wales that is NSW Fair Trading. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
Is it worth ordering spare parts with the kitchen?
A spare hinge or two and a length of matching edging, yes, and they cost very little alongside the kitchen. Years later a door that takes a knock is a five minute fix if the part is in a drawer and a much longer one if it has to be matched to a finish that may have moved on. Ask for it to be added as a line on the quote rather than assuming it is included.
What actually ships with the order?
A numbered plan and elevations, a service drawing marking every waste, water point and outlet for your Blacktown plumber and electrician, the hardware bagged per cabinet, kickboards and end panels cut to length, and fillers where the room needs them. Nothing on that list is an extra. The service drawing in particular is what stops a cabinet being cut on site to clear a pipe nobody planned for.
Who gets the cartons off the truck in Blacktown?
You do, or whoever you arrange. Freight to a residential address is generally kerbside, and a kitchen is a lot of cartons, several of them long and heavy enough to want two people. Builders usually have this handled. If you are doing it yourself, line up help and somewhere dry for the cartons before the delivery date rather than on the day.
Where else do you ship in Greater Sydney?
We ship to Penrith, Parramatta, Campbelltown, Liverpool, Hornsby, the Sutherland Shire, the Northern Beaches, Castle Hill and the rest of the region on the same route. The Greater Sydney page covers the region, and New South Wales covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Blacktown
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in New South Wales.
The specification
Built for this
climate, not a catalogue.
The seasonal swing here moves timber and board more than a steady climate does, and the joint that gives first is almost always the edge. Laser-bonded edging is fused to the panel rather than glued to it, so there is no seam to lift.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Blacktown kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Under-sink storage
Organisers shaped around the trap and the waste, which is the reason that cupboard is usually wasted.
See how it works →
Magic corner pull-out
The blind corner stops being the cupboard you empty twice a year. The front tray swings out and the back tray follows it.
See how it works →
Plate and pot racks
Pegs and rails inside a deep drawer so plates stand up and pots stop stacking into each other.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Blacktown — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Blacktown?
Yes. Blacktown is served south along the Pacific and New England highways, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Blacktown?
No. Our own installation team works Central Queensland only. In Blacktown your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Blacktown?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most Greater Sydney orders go flat.
Who can do the plumbing and electrical in Blacktown?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In New South Wales, NSW Fair Trading is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
Is there a deposit to get a Blacktown quote?
No. The drawing and the itemised quote cost nothing and carry no obligation. Payment terms for the order itself are stated on that quote.
Can I add pull-downs and organisers to a Blacktown kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Blacktown order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Blum runners fitted before it leaves
Stone on a compact run
Timber island, stone top
Blacktown, NSW
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Blacktown kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.