Kitchen cabinetry
shipped to Bicheno.
Cut to your wall lengths and your ceiling height, pre-drilled, labelled per cabinet and freighted to Bicheno flat or assembled. You decide which after you see both on the same quote.
The short answer
A Bicheno kitchen is quoted from your measurements and photographs, not from a site visit, and the quote is fixed and itemised with freight shown as its own line. It is cut in Rockhampton and ships south then by sea across Bass Strait. You choose flat packed or delivered assembled on the same drawing. Fitting is done by your own trades — our installation team works Central Queensland only.
What is a kitchen up against in Bicheno?
Salt air is relentless on hardware. It gets into unbranded runners and hinges and they stiffen, then sag, and the doors stop lining up. Every cabinet runs soft-close hinges and full-extension runners. Holiday housing that sits cold and closed for months, then gets used hard for six weeks.
How is a Bicheno order freighted?
Your kitchen is cut in Rockhampton and freighted south then by sea across Bass Strait. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Bicheno?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in Tasmania that is Consumer, Building and Occupational Services. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
What goes wrong with cheap cabinetry first?
In a predictable order: the edging lifts near the sink and the dishwasher, then water gets into the exposed core and the panel swells, then the drawer runners start to drag, then the doors stop lining up because the hinges have no adjustment left. None of that is bad luck. It is what 16mm standard-core board with glued edging and unbranded hardware does, and it is the reason we do not sell it.
What happens if something arrives damaged?
Check the delivery against the numbered drawing on the day it lands in Bicheno, before the truck leaves if you can. Count the cartons, look at the door and drawer fronts. If a panel is damaged or a carton is missing, photograph it and ring the studio the same day. A replacement is cut from the drawing we hold on file, so it matches the rest of the kitchen rather than being re-measured from scratch.
Can I change the drawing after I approve it?
Before it is cut, yes, and changes at that stage cost nothing but time. Once the panels are cut they are cut to your sizes and cannot be re-used on another job, which is why the approval step exists and why we would rather you took an extra week over it. Read the elevations as carefully as the plan: most late changes are about where a door swings or which side of the sink the dishwasher sits, and both are obvious on the elevation.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Bicheno
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in Tasmania.
The specification
Built for this
climate, not a catalogue.
The cold itself is not the problem. The problem is the damp that comes with it, settling in the parts of a kitchen that never get looked at until a door stops closing. Moisture-resistant board and a fused edge are specified for those places.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Bicheno kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Drawer organisers
Cutlery, knives and spices in fitted trays cut to the drawer, instead of a plastic tray that slides around in it.
See how it works →
Deep drawer fit-out
Dividers and rails that keep a deep drawer from turning into a single pile you dig through.
See how it works →
Tall larder pull-out
Full-height tiers on runners, so nothing lives at the back where you forget you bought it.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Bicheno — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Bicheno?
Yes. Bicheno is served south then by sea across Bass Strait, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Bicheno?
No. Our own installation team works Central Queensland only. In Bicheno your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Bicheno?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most the Tasmanian East Coast orders go flat.
Who can do the plumbing and electrical in Bicheno?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In Tasmania, Consumer, Building and Occupational Services is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
How long will a Bicheno order take?
It depends on the kitchen and the freight route, so it is stated on your quote for your job rather than guessed here. What you can plan around is the sequence: drawing, your sign-off, cutting, then freight.
Can I add pull-downs and organisers to a Bicheno kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Bicheno order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Black joinery, marble bar
Blum runners fitted before it leaves
Long island, one delivery
Bicheno, TAS
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Bicheno kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.