Built or flat packed,
delivered to Armadale.
The cabinetry that goes into a Armadale kitchen is the same cabinetry we put in our own installed jobs: 18mm moisture-resistant board, laser-bonded edging, Blum hardware. What differs is that your trades fit it rather than ours.
The short answer
We supply Armadale, we do not install there. The cabinetry is cut to your wall lengths and ceiling height rather than selected from catalogue widths, then freighted west across the Nullarbor as flat cartons or as assembled cabinets, whichever your quote compares better on. Specification is the same either way and the same in every state: 18mm moisture-resistant board, laser-bonded edging, Blum hinges and full-extension runners.
What brief does Armadale actually set?
Tight entries, shared driveways and a lift if you are lucky. Measuring the path from the truck to the room matters as much as measuring the room, and it is the question that usually decides flat pack over assembled on these jobs. The longest freight run we do, and the one where flat pack versus assembled is decided almost entirely by the freight line.
What is the run to Armadale?
Your kitchen is cut in Rockhampton and freighted west across the Nullarbor. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Armadale?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in Western Australia that is the WA Building and Energy division. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
How do I measure from Armadale with nobody visiting?
Because we do not visit Armadale, your measurements are the drawing. Wall to wall at three heights and use the smallest number. Ceiling height in every corner, because floors are never level. Every window and door with its distance from the nearest corner. Where the waste, the water and the power are now. Then a photograph of each corner of the room. Our measuring guide lists the lot, and a designer checks your numbers against the photographs before anything is cut.
How do I compare this with a Armadale cabinetmaker?
Take our itemised quote to any Armadale cabinetmaker and compare it line for line, which is exactly what it is formatted for. Ask them three things: board thickness and moisture rating, edging method, hardware brand. If the answers match ours and the number is better, take theirs - a local supplier with the same specification and no freight line is a genuinely good outcome. If the answers are vague, you have learned something either way.
Can you match something I have already seen?
Usually, if what you like is the door, the colour and the proportion rather than a specific brand's product. Send photographs with the quote request and say what it is you are responding to in them, because that is more useful than a style name. Our styles guide works through the eighteen looks people ask for most and what each one actually needs.
Where else do you ship in Greater Perth?
We ship to Joondalup, Rockingham, Mandurah, Ellenbrook, Fremantle, Midland, Kalamunda, Byford and the rest of the region on the same route. The Greater Perth page covers the region, and Western Australia covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Armadale
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in Western Australia.
The specification
Built for this
climate, not a catalogue.
The seasonal swing here moves timber and board more than a steady climate does, and the joint that gives first is almost always the edge. Laser-bonded edging is fused to the panel rather than glued to it, so there is no seam to lift.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Soft-close hinges and full-extension runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
What goes inside it
Anyone can sell you boxes.
This is the part that takes knowing.
Carcasses and doors decide how long it lasts. The fittings decide whether you like using it — and most suppliers charge for them at the end. These are included in your Armadale kitchen, not quoted as extras once the number is agreed. That is the difference, and it is the one most suppliers will not match.
Deep drawer fit-out
Dividers and rails that keep a deep drawer from turning into a single pile you dig through.
See how it works →
Tall larder pull-out
Full-height tiers on runners, so nothing lives at the back where you forget you bought it.
See how it works →
Under-sink storage
Organisers shaped around the trap and the waste, which is the reason that cupboard is usually wasted.
See how it works →There are seven in all — see the full range.
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call (07) 4863 5788 — you get the person who designs it.
Frequently asked
Armadale — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Armadale?
Yes. Armadale is served west across the Nullarbor, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Armadale?
No. Our own installation team works Central Queensland only. In Armadale your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Armadale?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most Greater Perth orders go flat.
Who can do the plumbing and electrical in Armadale?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In Western Australia, the WA Building and Energy division is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and soft-close hinges and full-extension runners on every cabinet, in every state, with the hardware brand named on your quote. The specification is printed on your quote so you can hold it against anything else you are offered.
Can I see a sample before ordering in Armadale?
Yes. Door, board and edging samples are posted out, and for most people that settles the colour question better than a screen does. Ask when you send the dimensions through.
Can I add pull-downs and organisers to a Armadale kitchen?
Yes, and they are quoted per item rather than bundled into a package you did not ask for. Pull-down wall baskets, magic corners, tall larder pull-outs and drawer organisers can all go into a Armadale order. If you order delivered assembled they are fitted before it ships; flat packed, they arrive with the cabinet they belong to.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Service drawings for your trades
Stone on a compact run
New build, kitchen fitted at fit-off
Armadale, WA
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Armadale kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.