Kitchen cabinetry
shipped to Glenelg.
Cut to your wall lengths and your ceiling height, pre-drilled, labelled per cabinet and freighted to Glenelg flat or assembled. You decide which after you see both on the same quote.
The short answer
A Glenelg kitchen is quoted from your measurements and photographs, not from a site visit, and the quote is fixed and itemised with freight shown as its own line. It is cut in Rockhampton and ships west via the Barrier and Sturt highways. You choose flat packed or delivered assembled on the same drawing. Fitting is done by your own trades — our installation team works Central Queensland only.
What is a kitchen up against in Glenelg?
Salt air is relentless on hardware. It gets into unbranded runners and hinges and they stiffen, then sag, and the doors stop lining up. Every cabinet runs Blum soft-close hinges and full-extension runners as standard. A lot of 1960s and 70s houses on generous blocks, which is why second dwellings and garage conversions come up so often here.
How is a Glenelg order freighted?
Your kitchen is cut in Rockhampton and freighted west via the Barrier and Sturt highways. Flat cartons are labelled to a numbered drawing, one per cabinet where possible, with doors and fronts wrapped separately and the Blum hardware bagged against the cabinet it belongs to. Assembled orders arrive as finished boxes, doors hung and adjusted, which takes more truck space and shows as a higher freight line. Both are on the same quote so the choice is a number rather than a guess.
Who fits it in Glenelg?
Your builder, carpenter or kitchen installer, plus a licensed plumber and a licensed electrician for their parts. Ask each for a licence number and check it yourself — in South Australia that is SA Consumer and Business Services. Every order ships with dimensioned service drawings showing each waste, water point and outlet, so the trades rough in to the plan rather than to a guess. Our install guide sets out the three trades and the fixed order they work in.
How do I plan around the plumbing I already have?
Keeping the sink and the waste where they are is the single cheapest decision available in a kitchen renovation, and moving them is the one most likely to find a problem inside a wall. If the layout works with the existing points, keep them. If it does not, get the plumber to look before the drawing is approved rather than after the cabinets land in Glenelg.
Is it worth ordering spare parts with the kitchen?
A spare hinge or two and a length of matching edging, yes, and they cost very little alongside the kitchen. Years later a door that takes a knock is a five minute fix if the part is in a drawer and a much longer one if it has to be matched to a finish that may have moved on. Ask for it to be added as a line on the quote rather than assuming it is included.
Can I change the drawing after I approve it?
Before it is cut, yes, and changes at that stage cost nothing but time. Once the panels are cut they are cut to your sizes and cannot be re-used on another job, which is why the approval step exists and why we would rather you took an extra week over it. Read the elevations as carefully as the plan: most late changes are about where a door swings or which side of the sink the dishwasher sits, and both are obvious on the elevation.
Where else do you ship in Greater Adelaide?
We ship to Gawler, Mount Barker, Victor Harbor, Aldinga, Elizabeth, Salisbury, Noarlunga, Strathalbyn and the rest of the region on the same route. The Greater Adelaide page covers the region, and South Australia covers the state.
- Drawn to your measurements, not catalogue widths
- 18mm moisture-resistant board, laser-bonded edging
- Blum soft-close hinges and full-extension runners
- Pre-drilled and labelled per cabinet
- Service drawings for your plumber and electrician
- Fixed itemised quote, freight its own line
- Installation not offered in Glenelg
Kitchenettes for a granny flat, studio or short-stay unit start at $4,500 — see flat pack kitchenettes.
Building a second dwelling? Granny flat rules in South Australia.
The specification
Built for this
climate, not a catalogue.
The seasonal swing here moves timber and board more than a steady climate does, and the joint that gives first is almost always the edge. Laser-bonded edging is fused to the panel rather than glued to it, so there is no seam to lift.
The same three questions decide any kitchen anywhere: board thickness and moisture rating, edging method, hardware brand. Ours are 18mm moisture-resistant, laser-bonded and Blum, and they are printed on every quote. How to judge a flat pack.
- 18mm moisture-resistant board
- Laser-bonded edging, no glue line
- Blum soft-close hinges and runners
- Cut to your drawing, not catalogue widths
- Pre-drilled and labelled per cabinet
- Fixed itemised quote, freight its own line
No showroom. No account.
A person draws it.
Send the wall lengths, the ceiling height and a photo of each corner. A designer draws your kitchen to the room and sends the drawing back with a fixed, itemised quote — flat packed and delivered assembled, freight to your postcode on each.
- Nothing to pay to see the drawing or the quote
- Changes redrawn until the plan is right
- Cut only after you sign the drawing off
- Freight quoted as its own line, never folded in
Or call 0401 821 848 — you get the person who designs it.
Frequently asked
Glenelg — questions
If your question is not here, call the studio. We would rather talk it through than have you guess.
Ask us directly →Do you deliver flat pack kitchens to Glenelg?
Yes. Glenelg is served west via the Barrier and Sturt highways, and freight is quoted to your postcode as its own line on the quote rather than folded into the cabinetry price.
Do you install kitchens in Glenelg?
No. Our own installation team works Central Queensland only. In Glenelg your builder, carpenter or kitchen installer fits it, working from the dimensioned service drawings that ship with every order. Our install guide covers the three trades and the order they work in.
Should I order flat pack or assembled to Glenelg?
Both are quoted on the same drawing. Flat cartons ship for less and get through tight doorways; assembled arrives with carcasses built and doors adjusted so your installer is fitting rather than building. Over this distance most Greater Adelaide orders go flat.
Who can do the plumbing and electrical in Glenelg?
A licensed plumber and a licensed electrician, and you should check both licences yourself before they start. In South Australia, SA Consumer and Business Services is the register to check against.
What board and hardware do you use?
18mm moisture-resistant board, laser-bonded edging and Blum soft-close hinges and runners on every cabinet, in every state. The specification is printed on your quote so you can hold it against anything else you are offered.
How long will a Glenelg order take?
It depends on the kitchen and the freight route, so it is stated on your quote for your job rather than guessed here. What you can plan around is the sequence: drawing, your sign-off, cutting, then freight.
Delivered assembled
The assembly is done
before it arrives.
Carcasses built square on a bench, Blum hardware fitted, doors hung and adjusted to even gaps. On site you are fixing finished cabinets to a wall, not building them on the floor. Your builder or installer levels it, fixes it and fits the benchtop, working from our drawings. Prefer to build it yourself? The same kitchen ships flat pack.
Samples brought to you
Black joinery, marble bar
Timber island, stone top
Glenelg, SA
Send us the dimensions.
We will send back a number.
A fixed, itemised quote for your Glenelg kitchen, flat packed and delivered assembled, with freight to your postcode on each. Nothing to pay to see it.